Something to make the M14 grip easier to hold

This part makes the curved stock grip of the Tokyo Marui M14 series easier to hold.
It is 3D printed using black resin.

The grip angle is designed to be close to 20 degrees, similar to the MOE-K Grip.
When holding a curved stock normally, your elbows tend to open up, which can expose them from cover during survival games.
By adopting the angle of a modern AR grip, you can hold it more comfortably with your elbows tucked in, and also when prone shooting.

Installation involves directly attaching the part to the stock using a strong adhesive.
(We recommend products like Cemedine Super X Black: ttps://amzn.to/3ARyfR3)
The part is delivered unpainted. For secure adhesion, please do not paint the inside of this part.
This is to prevent the paint layer from peeling off and causing the part to detach.
Additionally, for the surface of the airsoft gun body where the part will be attached, it is recommended to lightly sand off the existing paint to expose the bare material before applying adhesive for better results.
Apply a generous amount of adhesive inside the grip part and a thin layer on the airsoft gun body for strong bonding.
It is advisable to secure the part with tape until the adhesive cures to prevent shifting.

*Due to the resin material and adhesive mounting, there is a risk of detachment and breakage if the airsoft gun is held solely by this grip. Please handle with care.
*We are not responsible for any incidents, including the airsoft gun falling due to breakage or detachment of this part.
*As this is a resin print, layer lines and support marks may be present. Please smooth them out with sandpaper.
*The package contains only the grip part. The M14 body shown in the product photos is not included.
*This part may be usable with M14 models other than the Tokyo Marui electric gun M14 series, but the curves may not match perfectly.
*This product is delivered unpainted. You may consider applying a rubber spray coating.